] to [
] in the sheet, you can configure and scan with general settings.[Basic Mode] Sheet
This sheet contains the basic settings among all the scan settings. If you operate them in order of [] to [] in the sheet, you can configure and scan with general settings.
] to [] in the sheet, you can configure and scan with general settings.[Select Source]
Selects the type, color, and where the original has been set. The image settings are adjusted according to the state of the original.
If you select [Magazine (Color/Platen Glass)] or [Document (Color/Feeder)], the irregularities in intensity and moires that occur when scanning printed matter can be reduced.
[Preview]
When the original is set on the platen, previews the current settings. The cropping frame that indicates the scanning area is displayed as dotted lines in the preview.
In the preview, you can adjust the settings while checking the image.
[Select Purpose]
Enables you to select the purpose you are using the image for.
[Output Size]
Selects the printed size or displayed size of the image according to the purpose of use in [Select Purpose]. If you select [Flexible], you can change the size by dragging the cropping frame displayed in the preview.
If you select [Add/Delete], you can register the output size. You can register a maximum of 10 output sizes for each purpose of use in [Select Purpose].
[
Invert Aspect Ratio]
Invert Aspect Ratio]Changes the height and width of the cropping frame. You cannot use this if you select [Flexible].
[Fading Correction]
In a state where the image is displayed in the preview, corrects color fade in old photographs etc. to make a vivid images.
You can use this when [Photo (Color/Platen Glass)] or [Magazine (Color/Platen Glass)] is selected for [Select Source].
[Scan]
Scans the original with the current settings. When cropping frames have not been set, it scans the entire original.