Setting Up Connection Using WPS Push Button Mode
If your wireless router supports WPS push button mode, you can easily set up a connection with a WPS button.
|
How to operate the wireless router may vary on each device. See the instruction manuals for your networking device for help. |
1
Press 
.
.2
Use 
/
to select <Network Settings>, and press 
.
/ to select <Network Settings>, and press .If a screen for entering a PIN is displayed, enter the PIN with the numeric keys and press . Setting the System Manager PIN
. Setting the System Manager PIN3
Select <Wireless LAN Settings>, and press .
.If the <Enable the wireless LAN?> message is displayed, select <Yes>, and press .
.If the <Direct Connection will be disabled. Is it OK?> message is displayed, select <Yes>, and press .
.4
Read the message that is displayed, and press .
.5
Select <WPS Push Button Mode>, and press .
.
6
Select <Yes>, and press .
.
7
Press and hold the WPS button on the wireless router.
The button must be pressed within 2 minutes after pressing in step 6.
in step 6.Depending on the networking device, you may need to press and hold the button for 2 seconds or longer. See the instruction manuals for your networking device for help.
If an error message is displayed during setup
Press
and return to step 5.8
Check that the Wi-Fi indicator is blinking on the operation panel.
The Wi-Fi indicator blinks when a wireless router is detected.
When the setup is completed, the screen below is displayed, and approximately 2 seconds later, the Wi-Fi indicator lights up.
Wait approximately 2 minutes until the IP address settings of the machine are completed.
Signal strength
When more than one wireless router is available for connection, the machine connects to the device with the strongest signal. Signal strength is measured using RSSI (Received Signal Strength Indication).
 |
Reducing power consumptionYou can set the machine to enter <Power Save Mode> based on signals emitted from the wireless router. Power Save Mode If the IP address of the machine has changedIn a DHCP environment, the IP address of the machine may be changed automatically. If this happens, the connection is maintained as long as the machine and the computer belong to the same subnet. |