Setting Up Connection by Specifying Detailed Settings

If you want to specify the security settings in detail or cannot establish the wireless connection using the other procedures, manually enter all the required information for the wireless LAN connection. Before specifying detailed settings, check and write down the required information, including the SSID, network key, and wireless security protocols (Checking the SSID and Network Key).

Press

Use

to select <Network Settings>, and press

If a screen for entering a PIN is displayed, enter the PIN with the numeric keys and press

. Setting the System Manager PIN

Select <Wireless LAN Settings>, and press

If the <Enable the wireless LAN?> message is displayed, select <Yes>, and press

If the <Direct Connection will be disabled. Is it OK?> message is displayed, select <Yes>, and press

Read the message that is displayed, and press

Select <SSID Settings>

<Enter Manually>.

Enter the SSID that you have written down.

Enter the SSID using the numeric keys, select <Apply>, and press

. Entering Text

Specify the security settings based on the information that you have written down.

If you do not need to specify the security settings, select <None>, and press

Using WEP

1	Select <WEP>, and press .
2	Select an authentication method, and press . <Open System> Sets open system authentication, which is also called "open authentication." <Shared Key> Uses the WEP key as a password. When <Open System> is selected When connecting to a wireless LAN, the machine experiences an authentication error if the shared key authentication is set on the wireless router. If this happens, the machine automatically changes the setting to <Shared Key> and retries the connection.
3	Select <Edit WEP Key>, and press .
4	Select the WEP key (1 to 4) you want to edit, and press . Up to four WEP keys can be registered.
5	Enter the network key that you have written down. Enter the network key using the numeric keys, and select <Apply>, and press . Entering Text
6	Select <Select WEP Key>, and press .
7	Select the WEP key you have edited, and press .

Using WPA-PSK or WPA2-PSK

1	Select <WPA/WPA2-PSK>, and press .
2	Select an encryption method, and press . <Auto> Sets the machine to automatically select AES-CCMP or TKIP to match the setting of the wireless router. <AES-CCMP> Sets AES-CCMP as the encryption method.
3	Enter the network key that you have written down. Enter the network key using the numeric keys, select <Apply>, and press . Entering Text

Select <Yes>, and press

If an error message is displayed during setup

Press

, check whether the specified settings are correct, and return to step 5.

Check that the Wi-Fi indicator is blinking on the operation panel.

The Wi-Fi indicator blinks when a wireless router is detected.

When the setup is completed, the screen below is displayed, and approximately 2 seconds later, the Wi-Fi indicator lights up.

Wait approximately 2 minutes until the IP address settings of the machine are completed.

Signal strength
When more than one wireless router is available for connection, the machine connects to the device with the strongest signal. Signal strength is measured using RSSI (Received Signal Strength Indication).


Reducing power consumption You can set the machine to enter <Power Save Mode> based on signals emitted from the wireless router. Power Save Mode If the IP address of the machine has changed In a DHCP environment, the IP address of the machine may be changed automatically. If this happens, the connection is maintained as long as the machine and the computer belong to the same subnet.

Reducing power consumption

You can set the machine to enter <Power Save Mode> based on signals emitted from the wireless router. Power Save Mode

If the IP address of the machine has changed

In a DHCP environment, the IP address of the machine may be changed automatically. If this happens, the connection is maintained as long as the machine and the computer belong to the same subnet.

Connecting to a Wireless LAN