When the punch waste tray of the External 2/4 Hole Puncher-C1 or External 4 Hole Puncher-C1 becomes full, an animation screen prompting you to remove the punch waste appears on the touch panel display.
The location of the External 2/4 Hole Puncher-C1 or External 4 Hole Puncher-C1 is indicated in the following illustration.
Removing Punch Waste (External 2/4 Hole Puncher-C1/External 4 Hole Puncher-C1)
|
NOTE
|
|
The External 2/4 Hole Puncher-C1 and External 4 Hole Puncher-C1 are optional products.
The External 2/4 Hole Puncher-C1/External 4 Hole Puncher-C1 is available only when the Staple Finisher-T1 or Booklet Finisher-T1 is attached.
|
1.
Pull out the punch waste tray.
2.
Discard the punch waste.
|
NOTE
|
|
Make sure that the punch waste tray is completely emptied.
|
3.
Return the punch waste tray to its original position.
 |
1. Push the punch waste tray back into its original position. |
2. Close the front cover of the puncher. |
 CAUTION |
|
When closing the cover, be careful not to get your fingers caught, as this may result in personal injury.
|
|
NOTE
|
|
If the punch waste tray is not securely in place, you cannot make copies or prints in the Hole Punch mode.
|