Removing / Attaching the Long Sheet Tray
|
|
|
If a paper jam occurs when the long sheet tray is attached, use the following steps to remove the long sheet tray. After clearing the paper jam, re-attach the long sheet tray by following the procedure below.
|
Removing the Long Sheet Tray
1
Push the output tray back in, leaving approximately 3 1/8" (80.0 mm) of it still extended.
2
Remove the Long Sheet Tray.
Attaching the Long Sheet Tray
1
Pull out the upper output tray of the finisher to the maximum length.
2
Push the output tray back in, leaving approximately 3 1/8" (80.0 mm) of it still extended.
3
Attach the long sheet tray.
Attach the long sheet tray with its bent end facing down.
4
Pull out the output tray to the maximum length.
|
|
|
Make sure that the long sheet tray has been attached as described below.
1 The long sheet tray and the output tray are parallel.
2 There is a gap between the long sheet tray and the output tray.
 3 The long sheet tray has been attached on the outside of projections on each side
(only when there are projections).  |