Configuring Ethernet Settings
Ethernet is a standard for communicating data in a local area network (LAN). You can set the communication mode (half-duplex/full-duplex) and the Ethernet type (10BASE-T/100BASE-TX). In general, the machine can be used without changing the defaults (Ethernet Driver Settings), but you can change these settings to suit your network environment.
1
Tap <Menu> in the <Home> screen.
2
Tap <Network Settings>.
If a screen for entering a System Manager ID and PIN is displayed, enter the System Manager ID and PIN, tap <Apply>, and press 
. Setting the System Manager ID (imageRUNNER 2206N / 2006N)
. Setting the System Manager ID (imageRUNNER 2206N / 2006N)3
Select <Ethernet Driver Settings> 
<Auto Detect>.
<Auto Detect>.4
Select whether to configure Ethernet settings automatically or manually.
Configuring Ethernet settings automatically
Tap <On>. The machine detects and automatically sets the communication mode and the Ethernet type that can be used.
Configuring Ethernet settings manually
|
1
|
Tap <Off>.
|
|
2
|
Select the communication mode.
Tap <Communication Mode>
tap <Half Duplex> or <Full Duplex>.  <Half Duplex>Alternately sends and receives communication data. Select when the machine is connected to a networking device using half duplex.
 <Full Duplex>Simultaneously sends and receives communication data. Use this setting for most environments.
|
|
3
|
Select the Ethernet type.
Tap <Ethernet Type>
tap <10BASE-T> or <100BASE-TX>. |
|
4
|
Tap <Apply>.
|