Receiving I-Faxes
When an I-Fax Arrives
When an I-Fax arrives, the Data indicator on the operation panel blinks. After the I-Fax is completely received, the document is printed out automatically and the indicator goes out.
|
|
|
To cancel reception, select <Status Monitor>
 <RX Job> select a document in the <RX Job Status> tab <Delete> <Yes>. |
Receiving I-Faxes Manually
If you want to connect to the server before receiving I-Faxes automatically, or if you want to configure the machine so that it does not receive I-Faxes automatically, use the method below to receive I-Faxes manually. If there is a document on the server, printing begins.
<Status Monitor> <RX Job> <Check I-Fax RX>
<RX Job> <Check I-Fax RX>Printout Paper
Regardless of the received document size, incoming I-Faxes are printed at the size specified in <RX Print Size>. <RX Print Size>
|
|
|
If paper of the size specified in <RX Print Size> is not loaded in the paper drawer, the <No Paper> error message is displayed. Countermeasures for Each Message
|
 |
|
If you want to print received documents on both sides of paper: <Print on Both Sides>
If you want to continue printing even when the amount remaining in the toner cartridge is low: <Continue Print. When Cart. Low>
|