Changing the Finisher Output Priority Settings

You can give a priority to productivity or alignment for the output paper.

This mode can be set when the Staple Finisher-W PRO, Booklet Finisher-W PRO, Staple Finisher-AC or Booklet Finisher-AC (The Staple Finisher-AC or Booklet Finisher-AC must be attached along with the Finisher Jogger Kit-A) is attached. (See "Staple Finisher-W PRO/Booklet Finisher-W PRO/Puncher Unit-BS/Puncher Unit-BT,""Staple Finisher-AC/Booklet Finisher-AC/2/3 Hole Puncher Unit-A/2/4 Hole Puncher Unit-A.")

This mode can be set only if Thin paper 2 is used when the Staple Finisher-W PRO or Booklet Finisher-W PRO is attached.

Press

(Settings/Registration).

Press [Adjustment/Maintenance] → [Adjust Action] → [Finisher Output Priority Settings (Thin)].

Select [Productivity Priority] or [Alignment Priority] → press [OK].

Details of each item are shown below:

[Productivity Priority]	This mode gives a priority to productivity. The output paper may not be aligned.
[Alignment Priority]	As a priority is given to aligning the output paper, the production speed decreases compared with [Productivity Priority] mode.

NOTE
Paper can be output only to Tray C of a finisher when the Staple Finisher-AC, Booklet Finisher-AC, and Finisher Jogger Kit-A are attached. If the Staple Finisher-W PRO or Booklet Finisher-W PRO is attached, [Alignment Priority] is available only when outputting on Tray B of a finisher.