Scanned Originals Become Dirty (Manual Feeder Cleaning)

If streaks appear on originals fed through the feeder, or if smudges appear on printouts, or if a paper jam occurs frequently, then perform feeder cleaning.

Clean the feeder's scanning area with a cloth which is wrung after being dampened in water, and then wipe them clean with a soft, dry cloth.

The location of the Duplex Color Image Reader Unit-M is indicated in the following illustration.

IMPORTANT
If the document feed scanning area is dirty, documents may not be scanned clearly, and the size of the document may not be detected correctly.

NOTE
This procedure is necessary only if the Duplex Color Image Reader Unit-M is attached.

Pull the lever, and open the feeder cover.

Clean the rollers and surrounding areas of them inside the feeder cover.

	1.Wet a soft cloth with water and wring it out well, then wipe the rollers with it.
	2.Wipe the rollers with a soft and dry cloth.
	3.If the surrounding areas of the rollers are very dirty, clean them out as well.

IMPORTANT
Make sure that no trash such as pieces of paper gets into the groove of the multiple sheet feed detection sensor. If trash does get in, remove it using a soft cloth.

Gently close the feeder cover.

Clean the original scanning area (thin glass strip).

	1. Open the feeder.
	2. Clean the original scanning area.

NOTE
If you cannot remove the dirt, wet a soft cloth with water and wring it out well, then wipe the machine with it. Afterwards, wipe the machine with a soft and dry cloth. Use the glass cleaning cloth provided as a machine accessory of the Duplex Color Image Reader Unit-M when simple cleaning. When glass cleaning cloth becomes dirty, wash and rinse, and then spread it out to dry.

Open the document scan cover.

	1. Pull the lever above the feeder.
	2. Open the document scan cover.

IMPORTANT
Open the document scan cover carefully, as not to scratch the platen glass.

Open the inside cover.

Clean the feed scanning area (thin glass strip).

NOTE
Use the glass cleaning cloth provided as a machine accessory of the Duplex Color Image Reader Unit-M when simple cleaning. If you cannot remove the dirt, wet a soft cloth with water and wring it out well, then wipe the machine with it. Afterwards, wipe the machine with a soft and dry cloth. When glass cleaning cloth becomes dirty, wash and rinse, and then spread it out to dry.

Close the covers and the feeder.

	1. Close the inside cover.
	2. Close the document scan cover until it clicks into place.
	3. Close the feeder.

CAUTION
When closing the covers and the feeder, be careful not to get your fingers caught, as this may result in personal injury. Be aware that the light emitted from the platen glass may be very bright when closing the feeder.

NOTE
If originals or printouts still get dirty even after cleaning the feeder, try an automatic feeder cleaning. (See "Scanned Originals Become Dirty (Automatic Feeder Cleaning).")

Scanned Originals Become Dirty (Manual Feeder Cleaning)

1.Wet a soft cloth with water and wring it out well, then wipe the rollers with it.

2.Wipe the rollers with a soft and dry cloth.

3.If the surrounding areas of the rollers are very dirty, clean them out as well.

1. Open the feeder.

2. Clean the original scanning area.

1. Pull the lever above the feeder.

2. Open the document scan cover.

1. Close the inside cover.

2. Close the document scan cover until it clicks into place.

3. Close the feeder.