Paper Alignment on Finisher Tray A/B/C
You can adjust paper alignment when outputting on Tray A, B, or C of a finisher.
For Tray A or B of a finisher, this mode can be set when the Staple Finisher-W PRO or Booklet Finisher-W PRO is attached. (See "Staple Finisher-W PRO/Booklet Finisher-W PRO/Puncher Unit-BS/Puncher Unit-BT/Puncher Unit-BU.")
For Tray C of a finisher, this mode can be set when the Staple Finisher-AC, Booklet Finisher-AC, and Finisher Jogger Kit-A are attached. (See "Staple Finisher-AC/Booklet Finisher-AC/2/3 Hole Puncher Unit-A/2/4 Hole Puncher Unit-A/4 Hole Puncher Unit-A.")
For Tray C of a finisher, this mode can be set when the Staple Finisher-AC, Booklet Finisher-AC, and Finisher Jogger Kit-A are attached. (See "Staple Finisher-AC/Booklet Finisher-AC/2/3 Hole Puncher Unit-A/2/4 Hole Puncher Unit-A/4 Hole Puncher Unit-A.")
IMPORTANT |
You cannot align output paper in the following situations: when using paper smaller than A5R when using different size paper together If you set [Align Output Paper of Diff. Sizes (Diff. Width)] to 'On' when the Staple Finisher-W PRO or Booklet Finisher-W PRO is attached, you can align output paper by paper width. (See "Aligning Output Paper of Different Width.") |
1.
Press 
.
.2.
Press [Adjustment/Maintenance] → [Adjust Action] → [Finisher Tray A Alignment Adjustment], [Finisher Tray B Alignment Adjustment] or [Finisher Tray C Alignment Adjustment].
3.
Press [-] or [+] to adjust the paper alignment → [OK].
You can switch between positive and negative values by pressing [±].