Inner Finisher-H/Inner 2/4 Hole Puncher-B/Inner 2/3 Hole Puncher-B

Installing "Inner Finisher-H" enables you to use the following finish functions.
Collate
The printouts are collated into sets arranged in page order of the original.
 
Group
All printouts of the same original page are grouped together into sets.
 
Offset
Each printout group is shifted in alternating layers.
 
Staple + Collate
The printouts are collated into sets arranged in page order and stapled (Corner/Double).
 
Staple + Group
All printouts of the same original page are grouped together into sets and stapled (Corner/Double).
 
Staple Free
The printouts are crimped and bound without using a staple. You can easily split the paper by pressing the crimped part with your fingers. This function is useful for saving staples and also binding printouts briefly.
For information on the paper sizes that can be used for Staple Free, see Inner Finisher-H.
For information on the functions or paper that cannot be used with Staple Free, see Restrictions Regarding the Combination of Functions . The following are unavailable depending on the staple position.
Paper not available for two-sided printing
Mixed paper sizes
Depending on the usage environment and paper type, the crimped part may be split easily.
Manual Stapling
You can manually staple printed paper by inserting paper in the slit. As an example of use, you can remove staples bound to the document, copy or scan it, and then staple the document again.
TIPS
If you install the "Inner 2/4 Hole Puncher-B" or "Inner 2/3 Hole Puncher-B" in the "Inner Finisher-H," you can punch holes in your printouts.

External View

Auxiliary Tray

Pull out the auxiliary tray if you are outputting large size paper.

Output Tray

Paper is output to the output tray.

Staple Button

Press this button when you manually staple paper (Manual Stapling). You can also staple paper without pressing the button. You can specify the time period for the paper to be stapled after inserting the paper. <Adjust Action>  <Time Until Stapling Starts in Stapler Mode>

Slit

Insert paper to manually staple the paper. You can specify the time period for the paper to be stapled after inserting the paper.

Punch waste tray (Inner 2/4 Hole Puncher-B/Inner 2/3 Hole Puncher-B)

Pull out to discard punch waste. Emptying the Punch Waste (Optional)

Front cover

Open to remove jammed paper, clear a staple jam in the stapler unit, or replace the staple cartridge.
Selecting the Staple Position
Manual Stapling
Making Punch Holes
For information on the paper sizes that can be used for Staple and Hole Punch, see Inner Finisher-H.
To replace the staple cartridge of the stapler unit, see Loading Staples (Optional).
For how to clear a paper jam or a staple jam, see Clearing Paper Jams and Clearing Staple Jams (Optional).
The maximum number of bindable sheets may not be possible, depending on the paper type. In this case, change the paper type, or reduce the number of sheets to bind.
Collate and group
If you select <Offset> in combination with the collate or group function, each printout group is shifted.
Staplers
When you are using the Staple mode, do not remove the stack of paper from the output tray during the job. Remove the stack of paper when the job has been completed.
If the <Load staples into the stapler unit.> message appears, almost all of the staples have been used. To proceed, replace the staple cartridge.
Output temporarily stops when the tray reaches the lowest position or when 30 sets have been stapled. Printing resumes when you remove all of the paper that has been output.
6CRW-0X8