Long Sheet Tray-B
This tray supports long paper whose length is 19 1/4" (487.8 mm) or more in the feeding direction.
|
For information on the available paper, see "Available Paper." |
Extension output tray
This tray is designed to be attached to a finisher. Attach it to the upper tray (Tray A) of the Staple Finisher-W PRO or Booklet Finisher-W PRO.
For the Booklet Finisher-AC, attach it to Tray C.
Extension supply tray
This tray is designed to be attached on the paper inlet side of the main unit.
Loading Paper into the Long Sheet Tray-B (Optional)
This tray enables long paper to be fed into the machine. Using this tray requires the Stack Bypass Alignment Tray-D.
 | ||||
Do not use curled paper. Doing so may cause a paper jam or printing error. Precautions Regarding the Curling of Paper Be sure to correctly set the paper type. When printing on special types of paper, such as heavy paper or transparencies, be sure to correctly set the paper type, especially if you are using heavy paper. If the type of paper is not set correctly, it could adversely affect the quality of the image. Moreover, the fixing unit may become dirty and require a service repair, or the paper could jam. You cannot use finishing functions such as folding or stapling with this tray. Check that the extension supply tray is attached correctly. Paper jams may occur if it is not attached correctly.
Some thick paper, depending on the paper type, may cause paper jams if several sheets are loaded into the Long Sheet Tray-B. In this case, adjust the curl correction level to the plus side. (The curl amount should be set to 1/4" (5 mm) or less.) Curl Correction for Each Paper Drawer |
 |
For information on paper that can be loaded, see "Available Paper." |
1
Loosen the four fixing screws of the paper alignment guides of the Stack Bypass Alignment Tray-D.
2
Adjust the position of the paper guides to the size of the paper to be loaded.
 | Adjust the position of the paper alignment guides. |
 | Adjust the position of the paper guides of the multi-purpose tray.  |
3
Tighten the four fixing screws.
4
Load the paper into the Long Sheet Tray-B.
Only one sheet can be set at one time.
Check that the loaded paper stack lies flat. If the distance between the paper alignment guides is smaller than the paper width, the central area of the paper may become slightly raised. In this case, paper feeding may not be possible.
5
Check the paper size and paper type, and press <OK>.
If you load free size paper, or if the displayed size or type is different from the actual paper that is loaded, see Specifying Paper Size and Type in the Multi-purpose Tray.