Making Ethernet Settings
Ethernet is a standard that stipulates communication methods within a LAN. Normally, the communication system (half-duplex/full-duplex) and Ethernet type (1000BASE-T/100BASE-TX/10BASE-T) can be set automatically. You can set them separately by switching the setting to manual operation.
<Ethernet Driver Settings> exists for both the main line and sub line. Register the settings as necessary.
1
Press 
(Settings/Registration).
(Settings/Registration).2
Press <Preferences> 
<Network> <Ethernet Driver Settings>.
<Network> <Ethernet Driver Settings>.To specify the Ethernet settings for the sub line, press <Preferences> <Network> <Sub Line Settings> <Ethernet Driver Settings>.
<Network> <Sub Line Settings> <Ethernet Driver Settings>.3
Make Ethernet settings.
Normally, press <On> in <Auto Detect>. The communication system and Ethernet type are detected and automatically configured.
Making Ethernet settings manually
1 | Press <Off> in <Auto Detect>. |
2 | Select the communication system.   <Half Duplex>Carry out send/receive functions alternately. Select this when the connected router is set for half-duplex communication.  <Full Duplex>Carry out send/receive functions at the same time. Select this as a general rule. |
3 | Select the Ethernet type. Select <10BASE-T>, <100BASE-TX>, or <1000BASE-T> in <Ethernet Type>. |
4
Press <OK>.
5
Press (Settings/Registration) <Yes>.
(Settings/Registration) <Yes>.