Paper Alignment on Finisher Tray A/B
You can adjust paper alignment when outputting on Tray A or B of a finisher.
This mode can be set when the Finisher-AN or Saddle Finisher-AN is attached. (See "Finisher-AN/Saddle Finisher-AN/Puncher Unit-BS/Puncher Unit-BT/Puncher Unit-BU.")
IMPORTANT |
You cannot align output paper in the following situations: when using paper smaller than A5R when using different size paper together If you set [Align Output Paper of Diff. Sizes (Diff. Width)] to 'On', you can align output paper by paper width. (See "Aligning Output Paper of Different Width.") |
1.
Press 
.
.2.
Press [Adjustment/Maintenance] → [Adjust Action] → [Finisher Tray A Alignment Adjustment] or [Finisher Tray B Alignment Adjustment].
3.
Press [-] or [+] to adjust the paper alignment → [OK].
You can switch between positive and negative values by pressing [±].