Configuring LPD, RAW, or WSD

Select whether to use any of the protocols below on the machine when printing or scanning documents from a computer.
You are recommended to disable any protocols you will not be using.
When using LPD or RAW, you can configure the time until reception of print data is canceled.

LPD

This protocol is not dependent on the hardware, operating system, or other platform. It is commonly used in TCP/IP network environments.

RAW

This is Windows' proprietary print data type protocol. It is used as standard in a Windows environment.

WSD

This protocol enables automatic detection of network-connected printers and scanners in a Windows environment.

This section describes how to configure the settings using Remote UI from a computer.
On the operation panel, select [Menu] in the [Home] screen, and then select [Preferences] to configure the settings. [TCP/IP Settings]
Administrator privileges are required. The machine must be restarted to apply the settings.

On the Portal page of Remote UI, click [Settings/Registration]. Portal Page of Remote UI

Click [Network Settings].

Configure LPD, RAW, or WSD.

When Configuring LPD

1	Click [LPD Settings] [Edit]. The [Edit LPD Settings] screen is displayed.
2	Set whether to use LPD. When not using LPD, clear the [Use LPD Printing] checkbox, and proceed to step 5.
3	Enter the time in [RX Timeout]. Enter the time in minutes from the start of reception standby, after print data reception is canceled, to the timeout.

When Configuring RAW

1	Click [RAW Settings] [Edit]. The [Edit RAW Settings] screen is displayed.
2	Set whether to use RAW. When not using RAW, clear the [Use RAW Printing] checkbox, and proceed to step 5.
3	Enter the time in [RX Timeout]. Enter the time in minutes from the start of reception standby, after print data reception is canceled, to the timeout.

When Configuring WSD

Click [WSD Settings]

[Edit].

The [Edit WSD Settings] screen is displayed.

Set whether to use WSD for each function.

When not using WSD, clear the checkbox of the function for restricting use of WSD.

Using WSD to Print Data

Select the [Use WSD Printing] checkbox.
The [Use WSD Browsing] checkbox is selected automatically, and WSD is used to obtain the information of the machine from the computer.

Using WSD to Scan Data

Select the [Use WSD Scanning] checkbox. You can perform scanning from a computer without having to install a scanner driver.
To be able to specify a computer connected via WSD as the store location when scanning from the machine, also select the [Use Computer Scanning] checkbox.

When Responding to a Search Request of the Machine by Multicast Discovery

Select the [Use Multicast Discovery] checkbox.
To keep the machine in sleep mode without responding to received multicast discovery packets, clear the checkbox.

Click [OK].

Restart the machine. Restarting the Machine

The settings are applied.


Adding a WSD Network Device Click [] (Start) [] (Settings) [Devices] [Printers & scanners] [Add printers & scanners], and perform the operations following the instructions on the screen. For details about installing the driver via a WSD network, see the manual of the driver at the online manual site. https://oip.manual.canon/ Changing the Port Number To change the port number of each protocol, see the following: Changing the Port Number

Adding a WSD Network Device

Click [

] (Start)

[

] (Settings)

[Devices]

[Printers & scanners]

[Add printers & scanners], and perform the operations following the instructions on the screen.

For details about installing the driver via a WSD network, see the manual of the driver at the online manual site.
https://oip.manual.canon/

Changing the Port Number

To change the port number of each protocol, see the following:
Changing the Port Number