Adjusting the Paper Folding Position
When you are folding paper using an option with a fold function and the fold position is not where you intended, you can make fine adjustments to the fold position.
1
Press 
(Settings/Registration) 
<Adjustment/Maintenance> <Adjust Action> <Adjust Fold Position>.
(Settings/Registration) <Adjustment/Maintenance> <Adjust Action> <Adjust Fold Position>.2
Adjust the folding position.
When Adjusting the Saddle Fold Position
1 | Check the displayed instructions, and press <Next>. |
2 | Select the paper source with the loaded usable paper, and press <Start Printing>. The test page is output. |
3 | Select the current state of the fold position, and adjust the shift width.  Check the current state of the fold position and the shift width on the test page, then select the current state and set the shift width. |
4 | Press <OK>. |
5 | Press <Start Printing> to print the test page again, and check the adjustment results. To end the adjustment without printing the test page, press <Done>. |
6 | Press <Done>. If further adjustment is needed, press <Re-Adjust> and repeat Steps 3 to 5. |
When Adjusting a Position Other than the Saddle Fold
1 | Select the fold position to adjust. |
3
Press <OK>.