Replacing the Staple Case in the Saddle Stitcher Unit (Booklet Finisher-AC)

If there is any paper in the booklet tray, remove it.
1
Open the front cover of the finisher.
2
Pull out the saddle stitcher unit.
3
Remove the (two) staple cartridges while pulling down the lever towards yourself.
4
Remove the empty staple case.
Remove the empty staple case by lifting it up while holding it on both sides.
5
Remove the new staple case from its box.
6
Load the new staple case to the staple cartridge.
7
Install the (two) staple cartridges to the saddle stitcher unit.
Push them in as far as they will go.
8
Push in the saddle stitcher unit, and close the front cover of the finisher.
If stapling does not work after staples are replenished, perform staple repositioning manually. <Saddle Stitch Staple Repositioning> *
9Y3C-02H