Adjust Action
This section describes how to adjust image quality for copying and printing.
Saddle Stitch Staple Repositioning
Feeds papers to the saddle stitcher unit and staples them several times, and performs the saddle stitch staple repositioning procedure. The machine performs this adjustment procedure if stapling has not been performed after you clear a staple jam or replace the staple cartridge.
Adjust Saddle Stitch Fold Position/Stitch Position
You can adjust the saddle fold position and the saddle stitch position at the same time.
Adjust Double Staple Width
You can adjust the double staple width.
Switch Finisher Puncher Mode
You can set whether to give priority to the punching speed or to precision.
Speed/Precision Priority for Double Staple
You can set whether to give priority to the double stapling speed or to precision.
Adjust Trim Width
This function enables you to adjust the trimming width of Saddle Stitch printouts in 0.1 mm increments for each paper size.
Fine Adjust Perfect Binding Finishing Size
You can make fine adjustments to the trimming width of the Perfect Binder.
Adjust Perfect Binding Glue Application
When you make a booklet in the Perfect Binding mode, you must use the correct amount of glue or the bound booklet may be poorly finished, as shown the illustration below. In this case, adjust the amount of glue to improve the finishing condition of the booklet.
Color/B&W Priority for First Print Time
You can set whether priority is given to color or black-and-white printing for the first print time.
Adjust Fold Position
You can adjust the paper fold position when configuring the fold function.
Correct Curl for Each Paper Drawer
This mode enables you to adjust the curl correction level of each paper source.
Alignment Adjustment When Stapling
The copied or printed paper may shrink because of temperature, humidity, or a characteristic of the paper type. In this case, this mode enables you to align copied or printed papers by adjusting the position of the alignment guide inside the finisher so as to staple the aligned papers.
Finisher Tray A Alignment Adjustment
You can adjust paper alignment when outputting on Tray A of a finisher.
Finisher Tray B Alignment Adjustment
You can adjust paper alignment when outputting on Tray B of a finisher.
Finisher Tray C Alignment Adjustment
You can adjust paper alignment when outputting on Tray C of a finisher.
Finisher Output Priority Settings (Thin)
When Thin paper is used, you can give a priority to productivity or alignment for the output paper.
Finisher Output Priority Settings
You can give a priority to productivity or alignment for the output paper.
Time Until Stapling Starts in Stapler Mode
You can set the time until stapling is performed after inserting paper when using manual stapling.
Start Key Touch Recognition Delay
Adjust the touch time required to begin startup processing.