This setting is available only if your machine has multiple output trays. |
Device Configuration | Available Functions by Output Tray and Default Priority | Tray Location |
Inner 2way Tray-M | <Tray A> 1 Copy, 1 Access Stored Files, 1 Printer, 2 Receive, 2 Other, 2 Fax <Tray B> 2 Copy, 2 Access Stored Files, 2 Printer, 1 Receive, 1 Other, 1 Fax | |
Inner 2way Tray-M and Copy Tray-T | <Tray A> 1 Copy, 1 Access Stored Files, 1 Printer, Receive, Other, Fax <Tray B> 2 Copy, 2 Access Stored Files, 2 Printer, Receive, Other, Fax <Tray C> Copy, Access Stored Files, Printer, 1 Receive, 1 Other, 1 Fax | |
Inner Finisher-L | <Tray A> 1 Copy, 1 Access Stored Files, 1 Printer, 2 Receive, 2 Other, 2 Fax <Tray B> 2 Copy, 2 Access Stored Files, 2 Printer, 1 Receive, 1 Other, 1 Fax | |
Inner Finisher-L and Copy Tray-T | <Tray A> 1 Copy, 1 Access Stored Files, 1 Printer, Receive, Other, Fax <Tray B> 2 Copy, 2 Access Stored Files, 2 Printer, Receive, Other, Fax <Tray C> Copy, Access Stored Files, Printer, 1 Receive, 1 Other, 1 Fax |
If a certain tray reaches its stacking limit, the machine automatically uses another tray that is designated for the same function. However, it is recommended that you only designate one tray for fax/I-fax documents to prevent them from getting lost. |
The priority order of the output trays is determined by the order of the selected output trays. The priority is displayed as "1," "2," and "3." Select <Other> when printing reports. The fax function is displayed for device configurations with a fax board installed. Paper may not be output to the output tray specified with this setting, depending on the paper that is used and the finishing functions that are set. The paper sizes that can be output to each output tray differ according to the device configuration. For details, see Optional Equipment. When an output tray that does not support the Offset mode is selected in the output tray setting, the copies will not be output to the output tray according to the specified settings if <Offset> is enabled. Perform one of the procedures below to solve this problem. Disable <Offset at Same Time> in the auto collate settings. <Auto Collate> Specify an output tray that supports the Offset mode in the output tray settings. Manually disable <Collate> before executing the job. When <Use Optional Output Tray> is set to <Off>, the optional output tray cannot be selected as the output tray. <Use Optional Output Tray> |