Making Ethernet Settings
Ethernet is a standard that stipulates communication methods within a LAN. Normally, the communication system (half-duplex/full-duplex) and Ethernet type (1000BASE-T/100BASE-TX/10BASE-T) can be set automatically. You can set them separately by switching the setting to manual operation.
<Ethernet Driver Settings> exists for both the main line and sub line. Register the settings as necessary.
1
Select <Set> on the <Home> screen. <Home> Screen
2
Select <Preferences> 
<Network> <Ethernet Driver Settings>.
<Network> <Ethernet Driver Settings>.To specify the Ethernet settings for the sub line, select <Preferences> <Network> <Sub Line Settings> <Ethernet Driver Settings>.
<Network> <Sub Line Settings> <Ethernet Driver Settings>.3
Select whether to configure Ethernet settings automatically or manually.
Normally, set <Auto Detect> to <On>. The communication system and Ethernet type are detected and automatically configured.
Configuring Ethernet settings automatically
1 | Select <Auto Detect> <On>. |
Making Ethernet settings manually
1 | Configure a setting to disable Auto Detect. Select <Auto Detect> <Off>. |
2 | Select <Communication Mode> select the communication mode.<Half Duplex> Alternately sends and receives communication data. Select when the machine is connected to a networking device using half duplex. <Full Duplex> Simultaneously sends and receives communication data. Use this setting for most environments. |
3 | Select <Ethernet Type> select the Ethernet type.Select <10BASE-T>, <100BASE-TX>, or <1000BASE-T> in <Ethernet Type>. |