Configuring LPD, RAW, or WSD

Select whether to use any of the protocols below on the machine when printing documents from a computer.
You are recommended to disable any protocols you will not be using.
When using LPD or RAW, you can configure the time until reception of print data is canceled.
LPD
This protocol is not dependent on the hardware, operating system, or other platform. It is commonly used in TCP/IP network environments.
RAW
This is Windows' proprietary print data type protocol. It is used as standard in a Windows environment.
WSD
This protocol enables automatic detection of network-connected printers in a Windows environment.
 
This section describes how to configure the settings using Remote UI from a computer.
On the control panel, select [Menu] in the [Home] screen, and then select [Preferences] to configure the settings. [TCP/IP Settings]
Administrator privileges are required. The machine must be restarted to apply the settings.
1
Log in to Remote UI in System Manager Mode. Starting Remote UI
2
On the Portal page of Remote UI, click [Settings/Registration]. Portal Page of Remote UI
3
Click [Network Settings].
4
Configure LPD, RAW, or WSD.
When Configuring LPD
When Configuring RAW
When Configuring WSD
5
Click [OK].
6
Restart the machine. Restarting the Machine
The settings are applied.
Adding a WSD Network Device
Click [] (Start) [] (Settings) [Devices] [Printers & scanners] [Add printers & scanners], and perform the operations following the instructions on the screen.
For details about installing the driver via a WSD network, see the manual of the driver at the online manual site.
https://oip.manual.canon/
Changing the Port Number
To change the port number of each protocol, see the following:
Changing the Port Number
9K4J-062