Connecting to a Wireless LAN by Setting the Details (Manual Setup Method)

You can connect to a wireless LAN router by manually entering all information of the router such as the SSID, network key, and security settings.
Administrator privileges are required to connect to a wireless LAN.
Required Preparations
Prepare the information of the wireless LAN router to which you want to connect, and keep it close by. Wireless LAN Router Information Required for Connection
When connecting to a wireless LAN router supporting WPA-EAP or WPA2-EAP for the security standard, set IEEE 802.1X. Using IEEE 802.1X
1
On the control panel, select [Menu] in the [Home] screenand press . [Home] Screen
2
Press [Preferences    [Network]    [Wireless LAN Settings]  .
The [Select Network] screen is displayed.
If the login screen appears, enter the System Manager ID and PIN, and then press [<Log In>]  . System Manager ID and PIN
If the message [Enable the wireless LAN?] appears, select [Yes] and press .
If the message [Cannot find the access point.] appears, select [Close] and press .
3
Select [Other Connections] and press .
4
Select [Manually Enter Network Name] and press .
The SSID input screen is displayed.
5
Enter the SSID, select [<Apply>], and press .
The [Security Settings] screen is displayed.
6
Select the security standard, and set the authentication and encryption.
When using WEP
1
Select [WEP] and press .
The [802.11 Authentication] screen is displayed.
2
Select the authentication method.
[Open System]
Uses open authentication.
* When you select this authentication method, an authentication error occurs when connected to a wireless LAN router that uses a shared key. The machine setting changes to [Shared Key] at this time, and an attempt to reconnect to the router is made.
[Shared Key]
Uses an encryption key for the password.
3
Select [Edit Encryption Key] and press .
4
Select an encryption key that is not registered, and press .
The encryption key input screen is displayed.
5
Enter the network key, select [<Apply>], and press .
The encryption key is registered to the [Encryption Key] screen.
6
Select [Select Encryption Key] and press .
7
Select a registered encryption key, and press .
When Using WPA-PSK, WPA2-PSK, or WPA3-SAE
1
Select [WPA/WPA2-PSK], [WPA2-PSK/WPA3-SAE], or [WPA3-SAE] to match the security settings of the wireless LAN router, and then press .
The Encryption Methodscreen is displayed.
2
Select the encryption method and press .
The encryption key input screen is displayed.
When you select [Auto], AES-CCMP or TKIP is set automatically according to the wireless LAN router to which you want to connect. Note that when you are using WPA3-SAE, the encryption method is set to AES-CCMP even if you select [Auto].
3
Enter the network key, select [<Apply>], and press .
When Using WPA-EAP or WPA2-EAP
Select [WPA/WPA2-EAP] and press .
When Not Using a Security Standard
Select [None] and press .
7
Select [Yes] and press .
8
When [Connected.] is displayed on the control panel, press .
When the machine is connected to the wireless LAN, [] appears on the [Home] screen.
9
Wait a few minutes.
By default, an IP address is set automatically.
To use a specific IP address, set this manually.
Setting IPv4 Addresses
Setting IPv6 Addresses
If an Error Message Appears during Operation and a Connection Cannot Be Established
Press , check the information of the wireless LAN router to which you want to connect, and repeat the procedure starting from Step 3.
A19F-015