Authenticating a Destination SFTP Server
Authenticating a SFTP server to connect to helps prevent erroneous sending to the wrong destination and information leaks.
This section describes how to configure the settings using Remote UI from a computer.
On the control panel, select [
Settings/Register] in the [Home] screen or other screen, and then select [Function Settings] to configure the settings. However, the control panel can only be used to select whether to authenticate a server. [Host Authentication for SFTP TX]
Administrator privileges are required.
On the control panel, select [
Settings/Register] in the [Home] screen or other screen, and then select [Function Settings] to configure the settings. However, the control panel can only be used to select whether to authenticate a server. [Host Authentication for SFTP TX]Administrator privileges are required.
1
Log in to Remote UI as an administrator.Starting Remote UI
2
On the Portal page of Remote UI, click [Settings/Registration]. Remote UI Portal Page
3
Click [Send] 
[Common Settings].
[Common Settings].The [Common Settings] screen is displayed.
4
Select the [Use Host Authentication for SFTP TX] checkbox.
5
Click [Public Key Settings] for [Public Key to Use at Authentication].
The [Public Key Settings] screen is displayed.
6
Click [Register].
The [Register Public Key] screen is displayed.
7
Enter the host name in [Host Name].
8
Click [Browse File], then specify the file to install.
9
Click [Start Installation].
The installed public key is registered to the list of host names on the [Public Key Settings] screen.
10
Log out from Remote UI.