NOTE
|
You cannot specify the finishing settings when the fax driver is selected.
|
[Finishing Not Specified]
|
Prints without specifying the finishing settings.
|
[Collate]
|
Outputs the specified number of sets separately in page order.
|
[Group]
|
Outputs the specified number of the same pages together.
|
NOTE
|
If the Details Window is not displayed, see the following.
If commands are not displayed on the ribbon of Desktop Editor, see the following to display them.
This operation can also be performed with the tool buttons on the toolbar. If tool buttons are not displayed on the toolbar of Desktop Editor, see the following to display them.
|
[Offset]
|
Outputs the specified number of sets with the position of every other set shifted. Can be selected if [Collate] or [Group] is selected as the finishing method.
Can only be selected when a finisher is attached to the printer.
|
[Rotate]
|
Outputs each set with the set rotated by 90 degrees. Can be selected if [Collate] or [Group] is selected as the finishing method.
Can be selected even when a finisher is not attached to the printer.
|
NOTE
|
[Offset] and [Rotate] cannot be selected at the same time.
If commands are not displayed on the ribbon of Desktop Editor, see the following to display them.
This operation can also be performed with the tool buttons on the toolbar. If tool buttons are not displayed on the toolbar of Desktop Editor, see the following to display them.
|
NOTE
|
The number of sets can be specified if the [Offset] check box is selected. The sets are output with the position shifted each number of sets specified here. This can be selected if [Collate] or [Offset] is selected as the finishing method.
If commands are not displayed on the ribbon of Desktop Editor, see the following to display them.
This operation can also be performed with the tool buttons on the toolbar. If tool buttons are not displayed on the toolbar of Desktop Editor, see the following to display them.
|
NOTE
|
If commands are not displayed on the ribbon of Desktop Editor, see the following to display them.
This operation can also be performed with the tool buttons on the toolbar. If tool buttons are not displayed on the toolbar of Desktop Editor, see the following to display them.
|
[Paper Output]
|
Specifies the output destination when printing. The output destination cannot be specified when [Booklet Printing] and [Fold + Saddle Stitch] are selected.
|
[Face Up/Face Down]
|
Specifies whether to output the printed side facing down or facing up.
|
[Printer Default]
|
Specifies the printed side according to the settings on the control panel of the printer.
|
[Face Down [Normal Output Order]]
|
Outputs the printed side facing down.
|
[Face Up [Reverse Output Order]]
|
Outputs the printed side facing up.
|
NOTE
|
You cannot specify whether to output the printed side facing down or facing up in [Rotate] if the [Face Up/Face Down] check box is selected.
|