[Finishing] Sheet
You can configure settings relating to finishing such as collating, stapling, etc.
| | |
Collate | Group | Offset |
| | |
Rotate | Hole Punch | Staple |
[Output Method]
Specifies a separating method when printing multiple copies.
[Collate]
Outputs the specified number of copies in page order.
[Group]
Outputs the specified number of copies with all pages having the same page number grouped together.
[Staple]/[Eco (Staple-Free)]
Staples the pages when outputting print data. Enable one of these then select the staple position. [Eco (Staple-Free)] crimps the paper without using staples.
The available staple positions vary depending on the output paper size, paper feed direction, and paper source method.
[Hole Punch]
Outputs printed pages with holes for binding. This function can only be used when enabled at the device. The type of punch holes you can select depends on the optional unit attached to the device.
[Rotate]
Outputs each print job at a 90 degree angle relative to the one before and after it.
[Fold]
Specifies the type of fold when outputting pages folded into one of a variety of patterns.
| | | | |
C-fold | Z-fold | Saddle fold | Accordion Z-fold | Double parallel fold |
[Details]
Specifies the fold pattern when [C-fold], [Half fold], [Saddle fold (advanced)], [Accordion Z-fold], or [Double parallel fold] is selected for the fold type.
NOTE If Z-fold and stapling are specified together, the fold direction of the Z-fold changes depending on the staple location.
[Output Destination]
Specifies a printed paper output destination.
Select [Stacker (stack area)] when outputting to a large capacity stacker.
[Offset]
Offsets each set of pages output.
[Specify Offset Interval]
Outputs pages so that each specified number of pages is offset.
Related Topics