Changing the Scan Settings (Fax)
This section describes how to change the following scan settings to send a fax.
|
For the instructions on how to send a fax, see "Basic Procedures for Sending Faxes."
|
Resolution
Specify the resolution.
Higher resolutions result in better image quality but require longer transmission times.
|
<200 x 100 dpi (Normal)>
|
For faxes that contain text
|
|
<200 x 200 dpi (Fine)>
|
For faxes that contain fine text
|
|
<200 x 200 dpi (Photo)>
|
For faxes that contain photographs
|
|
<200 x 400 dpi (Superfine)>
|
Achieves an even finer resolution than (Fine)
|
|
<400 x 400 dpi (Ultrafine)>
|
Achieves an even finer resolution than (Superfine)
|
Density
Specify the density.
|
[
 ] |
Decrease the density.
|
|
[
 ] |
Increase the density.
|
2-Sided Original
Set the scan settings for 2-sided original documents.
|
<Off>
|
The direction of 2-sided original documents are not set.
|
|
<Book Type>
|
Select this setting if the top and bottom of the images are the same on both pages.
|
|
<Calendar Type>
|
Select this setting if the top and bottom of the images on each page are opposite each other.
|
Sharpness
Adjust this setting to emphasize the outline of the image or decrease the contrast.
|
[
] |
To clearly capture halftone photos, adjust this setting to the appropriate level on the <-> scale. This can counteract the effect of moiré patterns (uneven gradation and striped patterns).
|
|
[
] |
To clearly capture text or lines, adjust this setting to the appropriate level on the <+> scale. It is best suited for scanning blueprints and very weak pencil manuscripts.
|