Basic Procedures for Sending Faxes
1
Place your fax.
MF4890dw
Up to 50 documents can be loaded into the feeder.
MF4880dw/MF4770n
Up to 35 documents can be loaded into the feeder.
2
Press [
] (FAX).
3
Specify the scanning settings as needed.
The settings specified here are effective only for the current sending operation. To make the settings effective for all the fax operations, see "
Changing the Default Fax Settings."
4
Specify the destination.
Specify destinations in the following ways:
by entering the fax number
by selecting a one-touch key
by selecting a coded dialing code
by selecting a group address
from the Address book
under sequential broadcasting
When the destination confirmation screen is displayed:
After confirming details of the destination, press [OK] to proceed to the next step.
|
If <One-Touch/Coded Dial TX Confirmation> is set to <On> and the destination is specified by One-Touch keys or Coded dialing codes, the screen is displayed.
|
5
Press [
] (Start).
When your fax is placed in the feeder:
The scan starts. Your fax is sent to the destination when the scan is complete.
When your fax is placed on the platen glass:
Perform the following procedure.
(1)
|
Press [ ] or [ ] to highlight the size of the original document, and then press [OK].
|
(2)
|
Place the next page on the platen glass, and then press [ ] (Start).
Press [ ] (Start) for each page.
|
(3)
|
When all documents are scanned completely, press [ ] or [ ] to highlight <Start Sending>, and then press [OK].
Your fax is sent to the destination.
|