Attention (Setting the IPv4 Address)

NOTE
Before changing settings:
Ensure that the machine is connected in network and the power of the machine is turned ON.
When using DHCP, BOOTP, or RARP:
You can select only one of these protocols: DHCP, BOOTP, or RARP.
When the machine is restarted, the values obtained from DHCP, BOOTP, and RARP will be displayed.
(Previously-specified address will be overwritten by the automatically-obtained addresses.)
Because it takes 2 minutes to check whether DHCP, BOOTP, and RARP are available, it is recommended that you set to <Off> when you do not use them.
When using DHCP:
If you switch OFF then ON the power of the machine, you may not be able to print. This is because a different IP address from the one that has been used is assigned.
When using DHCP, consult your network administrator and perform either of the following settings.
Specifying the DNS Dynamic Update function
 "Setting IPv4 DNS"
Specifying the settings so that the same IP address is always assigned when the machine starts up
The IP address obtained by DHCP, BOOTP, or RARP:
Even if <Auto IP> is set to <On>, the settings are specified by priority.
0AE1-0E1