Setting the IPv4 Address

Before setting the IP address, see "Attention (Setting the IPv4 Address)."
By default, the IPv4 address is obtained automatically.
The procedure below describes how to manually specify this IP address.
IMPORTANT
When the setup is complete:
You must restart the machine to activate these settings.
1
Press [] (Menu).
2
Press [] or [] to highlight <Network Settings>, and then press [OK].
If a System Manager PIN is specified:
Use the numeric keys to enter the System Manager PIN, and then press [OK].
3
Press [] or [] to highlight <TCP/IP Settings>, and then press [OK].
4
Press [] or [] to highlight <IPv4 Settings>, and then press [OK].
5
Press [] or [] to highlight <IP Address Settings>, and then press [OK].
6
Press [] or [] to highlight the method for setting the IP address.
<Auto Obtain>
Set the IP address using any of DHCP, BOOTP, RARP or Auto IP.
<Manual Obtain>
Manually assign an IP address for the machine.
This setting can be specified only when <Select Protocol> and <Auto IP> in <Auto Obtain> are set to <Off>.
7
Change the IP address settings.
For <Auto Obtain>:
For <Manual Obtain>:
For <Auto Obtain>:
(1)
Change <Auto Obtain> settings.
<Select Protocol>
<Off>
Set the IP address settings not to obtain the IP address automatically.
<DHCP>
Obtains the IP address using DHCP. (The DHCP server needs to be running.)
<BOOTP>
Obtains the IP address using BOOTP. (The BOOTP daemon needs to be running.)
<RARP>
Obtains the IP address using RARP. (The RARP daemon needs to be running.)
<Auto IP>
<Off>
Set the IP address settings not to obtain the IP address automatically.
<On>
The machine obtains the IP address automatically.
(2)
Press [] or [] to highlight <Apply>, and then press [OK].
For <Manual Obtain>:
This setting can be specified only when <Select Protocol> and <Auto IP> in <Auto Obtain> are set to <Off>.
(1)
Enter the IP address.
After it has been entered, press [OK].
(2)
Enter the subnet mask.
After it has been entered, press [OK].
(3)
Enter the gateway address.
After it has been entered, press [OK].
8
Press [] (Menu) to close the Menu screen.
9
Restart the machine.
It is necessary to restart the machine to take effect the settings.
Turn OFF the machine and wait for at least 10 seconds before turning it back ON.
0874-09S