Performing the Configuration Using the Printer's Control Panel (the Settings to Be Performed First)

When configuring the interface using the printer's control panel, use the following menu hierarchy.

*	[Communication Mode] and [Ethernet Type] are displayed when [Auto Detect] is set to [Off].

Pressing [ ] (Settings) displays the common Setup menu.
indicates that the procedure is performed by pressing [ ] or [ ] on the control panel.
indicates that the procedure is performed by pressing [OK] on the control panel.

IMPORTANT
After performing the configuration To enable the settings, perform a hard reset or restart the printer. For details on a hard reset, see "Canceling All the Jobs (Hard Reset)." To go back up the hierarchy Press [ ] (Back). About the control panel For details on the control panel, see "Control Panel."

IMPORTANT

After performing the configuration

To enable the settings, perform a hard reset or restart the printer.
For details on a hard reset, see "Canceling All the Jobs (Hard Reset)."

To go back up the hierarchy

Press [ ] (Back).

About the control panel

For details on the control panel, see "Control Panel."

Press [ ] (Settings), select [Std Network Menu] using [ ] and [ ], and then press [OK].

When the message is displayed, press [OK].

You can specify the settings when the printer is either online (the Online indicator is on) or offline (the Online indicator is off).

Select [Ethernet Driver] using [ ] and [ ], and then press [OK].

Configure the Ethernet driver.

This printer can detect the communication method and Ethernet type automatically. Normally, set [Auto Detect] to [On].
If you want to fix the communication method and Ethernet type, set [Auto Detect] to [Off].

When detecting the Ethernet driver automatically (Default)

1.	Select [Auto Detect] using [ ] and [ ], and then press [OK].
2.	Select [On] using [ ] and [ ], and then press [OK].

When detecting the Ethernet driver manually

Select [Auto Detect] using [ ] and [ ], and then press [OK].

Select [Off] using [ ] and [ ], and then press [OK].

Select [Communication Mode] using [ ] and [ ], and then press [OK].

Select an Ethernet communication method appropriate for your network environment using [ ] and [ ], and then press [OK].

[Half Duplex]:	Receives and transmits data alternately, not simultaneously.
[Full Duplex]:	Receives and transmits data simultaneously.

Select [Ethernet Type] using [ ] and [ ], and then press [OK].

Select an Ethernet type appropriate for your network environment using [ ] and [ ], and then press [OK].

Perform a hard reset or restart the printer.

After performing a hard reset or restarting the printer, the settings are effective.

NOTE
For details on a hard reset See "Canceling All the Jobs (Hard Reset)."