Changing the Network Transmission Speed or Transfer Mode
Configure the Ethernet driver for this printer using either of the following methods.
Configure the Ethernet driver using the control panel while checking the display on the printer.
Change the settings for the Ethernet driver by accessing the printer from a Web browser via the network.
|
IMPORTANT
|
When configuring the interface first
Use the printer's control panel. After configuring the TCP/IP protocol settings, you can change the settings for the interface using the Web browser (Remote UI).
|
|
NOTE
|
Ethernet
Ethernet is a LAN standard, and this printer supports 10Base-T/100Base-TX connections. When this printer is used on a network, the Ethernet driver controls the communication method and Ethernet type.
Displaying the Ethernet driver settings
The Ethernet driver setting can be displayed only if [Primary Network Setting] is set to [Standard Network]. Specify the setting for [Primary Network Setting] in the [Extension Card] page in the Remote UI or on the control panel.
|