NOTE
|
A Phillips screwdriver is required.Have a screwdriver ready that matches the size of the screws for the slot cover.
|
Shut down the printer before turning it OFF.
For details on the procedure for shutting down the printer, see "Turning the Printer ON/OFF." |
USB cable*
|
(2) Turn the computer OFF.
(3) Disconnect the cable from the printer.
|
LAN cable*
|
(4) Disconnect the cable from the printer.
|
Power cord
|
(5) Disconnect the power plug from the AC power outlet.
(6) Disconnect the cord from the printer.
|
*
|
Whether the cable is connected or not varies depending on your environment.
|
(1)
|
While holding the tab (A), open the cover a little.
|
(2)
|
Remove the cover in the direction of the arrow.
|
(1)
|
Remove the screw.
|
(2)
|
Open the slot cover.
|
(3)
|
Remove the cover in the direction of the arrow.
|
NOTE
|
About the location for installing ROMConfirm the installation location and its orientation before installing the ROM module.
|
(1)
|
Attach the slot cover.
|
(2)
|
Close the cover.
|
(1)
|
Attach the left cover.
|
(2)
|
Close the cover.
|
Next, perform the following procedures. (If you want to install the SD card, follow the procedure from Step 2 in "Installing SD Card".)
|