A Portion of the Page Is Not Printed (Printed Data Lies Outside Paper)

Perform one of the following solutions according to the cause.

<Cause 1> The setting for the scaling factor is not appropriate.

Solution 1
Perform the following procedure in the printer driver.
1.
Display the [Page Setup] sheet.
2.
Clear the [Manual Scaling] check box.
If the [Manual Scaling] check box is cleared, the scale factor will be set according to [Page Size] and [Output Size] automatically.
Solution 2
Perform the following procedure in the printer driver.
1.
Display the [Page Setup] sheet.
2.
Select the [Manual Scaling] check box, then specify an appropriate scale factor according to the paper size to be used.

<Cause 2> The position of the paper is incorrect.

Solution
Load the paper properly.

<Cause 3> A document with no margins was printed.

Solution 1
Data is printed with a margin of 5 mm (10 mm for envelopes). Provide a margin around the data.
Solution 2
Perform the following procedure in the printer driver.
1.
Display the [Finishing] sheet.
2.
Click [Advanced Settings].
3.
Set [Expand Print Region and Print] to [On].
Depending on the print data to be printed, the edge of paper may be missing partly during printing or may blot during color printing.

<Cause 4> The loaded paper is smaller than the paper drawer or the paper size setting for the job.

Solution
Load paper that matches the paper size setting, or change the paper size setting to match the paper.

<Cause 5> When printing the following paper, the paper is loaded with an orientation (feed direction) that differs from that of the paper drawer or the paper setting for the job.

A5 paper
Statement paper
Custom size paper with a width and length (height) between 127.0 and 215.9 mm
Solution
Load paper with the orientation (feed direction) that matches the paper setting, or change the setting of the paper feed direction to match the paper.
0F40-09K