Removing the Packing Materials
Carry the machine to the installation site and remove all of the orange tape and packing materials. Read the precautions in
Installation and
Handling before installing the SD card. The shape and location of the packing materials described here may differ from those used for your machine, as the packing materials may have been changed, added or removed without notice.
|
Save the packing materials
The box and packing materials included at the time of purchase will be needed when transporting the machine for relocation or maintenance.
When installing the optional paper feeder
Install the optional paper feeder at the machine installation site before moving the machine to the site. Installing the Paper Feeder
|
1
Check the installation site.
Installation Requirements
Install the machine in a location with the following characteristics:
Sufficient space
Ensure at least 100 mm on both right and left side of the machine.
Good ventilation
A flat, even surface
A stable surface able to fully support the weight of the machine
Environmental Conditions
Temperature: 10 to 30 °C
Humidity: 20 to 80 % RH (no condensation)
2
Remove the machine from the plastic bag and carry it to the installation site.
Use the handles on both sides of the machine, and have at least two people carry it.
Be sure to hold the lift handles
Do not move the machine by holding the duplex unit.
3
Open the front cover while holding down the button.
4
Hold the tape, and remove it with the packing materials.
5
Close the front cover.
6
Pull out the paper drawer until it stops, and remove it while lifting the front side.
7
Remove the Packing Materials.
8
Insert the paper drawer into the machine.
Insert the paper drawer at an angle, and then push it horizontally.
9
Install the protective cover on the rear side of the paper feeder.
|
Make sure that all the packing materials have been removed from the machine.
|
»