Interface
 |
All the settings about interfaces for communications with a computer and USB are listed with short descriptions. Default settings are marked with a dagger (
 ). |
|
|
Asterisks (*)Settings marked with an asterisk (*) are not displayed depending on other settings.
|
Interface Selection
Select the interface used for the machine.
USB
Enable or disable the USB port. Restricting the USB Connection with a Computer
|
Off
On
|
Network
Enable or disable the LAN port. Disabling the LAN Port
|
Off
On
|
USB Storage Device
Specify settings for the device driver for using a USB memory device.
MEAP Driver
Enable or disable the MEAP specific device driver when a USB memory device is attached to the machine. When you want to perform the direct print function (USB Direct Print) from a USB memory device without using a computer, select <Off>.
|
Off
On
|
(Settings) 
<Interface> 
<Interface Selection> Check the message <USB Storage Device> <MEAP Driver> <Off> or <On> Perform a hard reset (Performing a Hard Reset)Timeout
Specify how the machine should behave if receiving print data is interrupted.
Timeout
Select whether to cancel printing if print data receiving is interrupted for a specified period of time.
|
Off
On
|
(Settings) <Interface> <Timeout> <Timeout> <Off> or <On> Timeout Time *
Set the time period until a timeout error occurs.
|
5 to 15
to 300 (seconds) |
(Settings) <Interface> <Timeout> <Timeout Time> Use 
/ 
to set the time period Connection Recog.
A problem such as improper overlay printing or garbled characters may occur during printing via wired LAN connection. In this case, set <Connection Recog.> to <Off>.
|
Off
On
|
(Settings) <Interface> <Connection Recog.> Check the message <Off> or <On> Perform a hard reset (Performing a Hard Reset)Extended RX Buffer
Select whether to increase the space of the memory built in the machine for receiving print data from a computer. If you select <On>, the time until the computer will be freed from print data processing or transmission can be reduced when the computer sends a large volume of data or complicatedly structured data.
|
Off
On
|
(Settings) <Interface> <Extended RX Buffer> Check the message <Off> or <On> Perform a hard reset (Performing a Hard Reset)