How to Replace the Toner Cartridge
Read the precautions in Maintenance and Inspections and Consumables before replacing the toner cartridge.
1
Open the front cover while holding down the button.
2
Remove the toner cartridge.
3
Remove the replacement toner cartridge from the protective bag.
4
Hold the tape, and remove it with the protective sheet.
5
Shake the toner cartridge 5 or 6 times as shown below to evenly distribute the toner inside the cartridge, and then place it on a flat surface.
6
Pull the sealing tape straight out.
The full length of the sealing tape is approximately 70 cm.
When pulling out the sealing tape
If the sealing tape remains inside the toner cartridge, the quality of printouts may deteriorate.
If the sealing tape remains inside the toner cartridge, the quality of printouts may deteriorate.
Do not pull the sealing tape at an angle. If the tape breaks, you may not be able to pull it out completely.
If the sealing tape becomes stuck when pulling it out, keep pulling until it is completely removed.
7
Install the toner cartridge.
Align the toner cartridge against the toner cartridge guide (
), and make sure to push the cartridge until it stops.
), and make sure to push the cartridge until it stops.
8
Close the front cover.