Loading Envelopes
Make sure to flatten any curls on envelopes before loading them. Also pay attention to the orientation of envelopes and which side is face up.
|
|
|
This section explains how to load envelopes in the orientation you want, as well as preparations that you need to complete before loading envelopes. For a complete description of the procedure for loading envelopes in the multi-purpose tray, see Loading Paper in the Multi-Purpose Tray.
|
Before Loading Envelopes
Follow the procedure below to prepare the envelopes before loading.
1
Close the flap of each envelope.
2
Press down to expel air from the envelopes and make sure that the folds on all four sides are sharp and that the stack is flat.
3
Remove curls by flexing the stiff sections at the four corners.
4
Tap the stack on a flat surface to even the edges of the envelopes.
Loading Envelopes in the Multi-Purpose Tray
Load the envelopes Monarch, No. 10 (COM10), DL, or C5 in portrait orientation (with the short edge toward the machine), with the non-glued side (front side) face up. You cannot print on the reverse side of envelopes.
|
|
|
Load the envelopes so that the edge with the flap is toward the left side as shown in the illustration.
|
