Checking the SD Card Installation
After installing an SD card, print Configuration Page to check if the module is installed properly.
NOTE |
Load A4 size paper.Configuration Page is designed to be printed on A4 size paper. Be sure to load A4 size paper when printing the Configuration Page. |
1
Load A4 size paper in the multi-purpose tray or paper drawer.
2
Make sure that the printer is online.
If the printer is not online, press [
] (
Online).
3
Press [
] (
Utility).
4
Select [Configuration Page] using [
] and [
], and then press [OK].
5
Select [Yes] using [
], and then press [OK] to print Configuration Page.
NOTE |
How to check the installationConfirm that that [SD Card] under the [Control Menu] is set to [On]. → | If [SD Card] is not displayed, see " Removing SD Card," remove the SD card, and then try to install it again. |
→ | If [SD Card] is displayed, perform the following procedure. | | (1) | Press [ ] ( Settings). | (2) | Select [Control Menu] using [ ] and [ ], and then press [OK]. | (3) | Select [SD Card] using [ ] and [ ], and then press [OK]. | (4) | Select [On] using [ ] and [ ], and then press [OK]. | (5) | Perform a hard reset or restart the printer. |
|
→ | Check that the SD card is not write-protected. If the card is write-protected, release the protection, and then insert the card. |
| The above figure is a sample of Configuration Page. The contents may differ from the Configuration Page printed by your printer. |
|