Loading Envelopes
Make sure to flatten any curls on envelopes before loading them. Also pay attention to the orientation of envelopes and which side is face up. Note that envelopes cannot be loaded in the paper drawer.
|
|
|
This section describes how to load envelopes in the orientation you want, as well as procedures that you need to complete before loading envelopes. For the general procedure for loading envelopes in the multi-purpose tray or optional envelope feeder, see the following.
|
Before Loading Envelopes
Follow the procedure below to prepare the envelopes before loading.
 |
|
Envelopes cannot be ejected into the output tray. Make sure to open the sub-output tray.
 |
1
Close the flap of each envelope.
2
Flatten them to release any remaining air, and make sure that the edges are pressed tightly.
3
Loosen any stiff corners of the envelopes and flatten any curls.
4
Align the edges of the envelope on a flat surface.
Loading Envelopes in the Multi-Purpose Tray
Load the envelopes Monarch, COM10, DL, or ISO-C5 in portrait orientation (with the short edge toward the machine), with the non-glued side (front side) face up. You cannot print on the reverse side of envelopes. Use the same way to load envelopes in the envelope feeder.
|
|
|
Load the envelopes so that the edge with the flap is toward the left side as shown in the illustration.
|
