Inserting Image Stamps
With Desktop Editor, you can insert a registered image into a document as an annotation. Select the annotation to insert from the annotations registered as stamps.
|
NOTE
|
|
You can insert newly registered stamps, as well as the stamps that are registered automatically during installation. For more information, see the following.
Stamps registered by users can be edited. For more information, see the following.
|
1.
Select [Stamp] on the ribbon > select the image stamp to insert.
Or, select (Stamp) on the Details Window > ▼ > select the image stamp to insert.
The preview and properties of the selected stamps are displayed on the Details Window.
|
NOTE
|
|
The last stamp used can be selected by performing one of the following operations.
Click
 for [Stamp] on the ribbon Click
 for  (Stamp) on the Details WindowIf the Details Window is not displayed, see the following.
This operation can also be performed with the tool buttons. If tool buttons are not displayed on the toolbar of Desktop Editor, see the following to display them.
You can also insert image stamps multiple times. For more information, see the following.
|
2.
Configure the properties of the stamp.
|
[Transparency]
|
The slider position and the numeric value indicate the degree of transparency of the stamp. To change the degree of transparency, move the slider to the left or right, or enter a numeric value. You can also use
 to change the degree of transparency. |
|
[Restore Original Value]
|
Restores the changed stamp properties to the values set when the stamp was registered. This is only valid before inserting a stamp.
|
|
NOTE
|
|
The current settings are previewed in the top section of the properties.
Properties can also be set from ribbon commands or tool buttons. For information on the commands and tool buttons that can set properties, see the following.
|
3.
Move the mouse pointer to the Work Window.
The shape of mouse pointer becomes 
, and a preview of the selected stamp is displayed.
, and a preview of the selected stamp is displayed.|
NOTE
|
|
To cancel the insertion process, do one of the following.
Click
 (Select Object) on the ribbonClick
 (Select Text) on the ribbonClick
 (Grab Mode) on the ribbonClick
 for [Stamp] on the ribbonClick
 (Select Object) on the Details WindowClick
 (Select Text) on the Details WindowClick
 (Grab Mode) on the Details WindowClick
 for  (Stamp) on the Details WindowPress the [Esc] key on the keyboard
|
4.
Set the preview where you want to insert a stamp, and click it.
The stamp is inserted.
|
NOTE
|
|
When the edge of the stamp exceeds the edge of the page, the size of the stamp is automatically reduced to fit the page while the aspect ratio of the image is maintained.
You can change the size of the inserted stamp. For more information, see the following.
|
5.
Click on the Work Window outside the stamp you inserted to deselect the stamp.