[Finishing] Sheet
You can configure settings relating to finishing such as collating, stapling, etc.
 |
 |
 |
|
Collate
|
Group
|
Offset
|
 |
 |
 |
|
Rotate
|
Hole Punch
|
Staple
|
[Output Method]
Specifies a separating method when printing multiple copies.
[Collate]
Outputs the specified number of copies in page order.
[Group]
Outputs the specified number of copies with all pages having the same page number grouped together.
[Staple]
Staples the pages when outputting print data. Select staple position(s).
[On (Eco (Staple-Free))] crimps the paper without using staples.
The available staple positions vary depending on the output paper size, paper feed direction, and paper source method.
[Hole Punch]
Outputs printed pages with holes for binding. This function can only be used when enabled at the device. The type of punch holes you can select depends on the optional unit attached to the device.
[Offset]
Offsets each set of pages output.
[Specify Offset Interval: Every]
Outputs pages so that each specified number of pages is offset.
[Rotate]
Outputs each print job at a 90 degree angle relative to the one before and after it.
[Fold]
Specifies the type of fold when outputting pages folded into one of a variety of patterns.
 |
 |
 |
 |
 |
|
C-fold
|
Z-fold
|
Saddle fold
|
Accordion Z-fold
|
Double parallel fold
|
[Details]
Specifies the fold pattern when [C-fold], [Half fold], [Saddle fold (advanced)], [Accordion Z-fold], or [Double parallel fold] is selected for the fold type.
NOTEIf Z-fold and stapling are specified together, the fold direction of the Z-fold changes depending on the staple location.
[Crease]
Makes a crease in printed paper so that it is easier to fold.
You can also select the paper to crease.
[Trim]
Trims and aligns the edges of the pages when creating a booklet by stapling the pages in the middle.
[Details]
Enables you to set the trim width and adjustment method.
[Output Destination]
Specifies a printed paper output destination.
[Details]
Enables you to set stacking details when [Stacker (stack area)] is selected to output to a large capacity stacker.