If your Wireless LAN router is set to use WEP authentication, you might not be able to connect using the WPS PIN code method.
1
Access your wireless LAN router and display the WPS PIN code setting screen (operate on the computer).
For operation details, see the instruction manual of the wireless LAN router.
2
Select <Wireless LAN Settings> in the Home Screen.
When a message appears on the display of the machine, select <Yes>.
NOTE
If a message is displayed telling that no access point can be found, select <Close>.
3
Select <Other Connections>.
4
Select <WPS PIN Code Mode>.
The generated PIN code is displayed on the machine.
5
Register the generated PIN code on the wireless LAN router (operate on the computer).
Use the WPS PIN setting window in step 1.
You must register the PIN code within 10 minutes after selecting <WPS PIN Code Mode> in step 4.
If an error message is displayed while making settings, select <Close> and then start again from step 3.
6
Wait until <Connected.> is displayed on the machine.
7
Select <Close>.
Wait a few minutes for the IP address, etc. to be set automatically.
NOTE
If the IP address of the machine has been changed
In a DHCP environment, the IP address of the machine might be changed automatically. However, the connection is maintained as long as the machine and computer are on the same subnet.
If there are multiple wireless LAN routers that can be connected
Connect to the device with the strongest signal strength (RSSI).
This site uses cookies to provide its contents and functions and improve their qualities etc. You can find out more about our use of the cookies here. If you select "Reject", only cookies necessary to provide the contents and functions of the site are recorded and stored.