Set the receive mode to one of the following.
<Fax/Tel Auto Switch>
<Auto>
<Answering Machine>
"RX Mode"
When <Answering Machine> is set, make sure that an external telephone with the built-in answer function is connected to the machine. Also make sure that it is always turned on and the recorded answering message can be heard anytime.
|
Print, send, or delete jobs stored in memory.
|
See the following section:
|
Make sure the machine is set to receive faxes manually.
|
Select <Start Receiving> and press [OK]. Then, return the handset to its cradle or enter the remote receive ID. Otherwise, the call will be disconnected.
|
Remove the document from the feeder and receive the fax manually.
If [] (Start) is pressed when a document is set in the feeder, the document will be sent.
|
Use of the optical line is not guaranteed.
|
See the following section:
|
Adjust the paper guides of the paper drawer to fit the paper size.
|
Specify the correct paper size to load into the paper drawer.
|
Set <Reduce RX Size> to <On> before adjusting.
|
Contact the sender and verify that the resolution of the sender's machine has been set properly.
|
Make sure to set the telephone line type to tone dialing. If the type is set to the rotary pulse, press [] (Tone) to switch to tone dialing.
|
Follow the instructions provided from information services.
|
Ask the sender to check his/her fax machine.
|
Check the settings specified for 2-sided printing.
|