|
See the following section:
|
|
Check the setting for <Restrict History TX>.
|
|
Check the setting for <Fax No. Confirmation Re-Entry>.
|
|
Use of the optical line is not guaranteed.
|
|
Large documents or high quality settings may exceed the available memory capacity. Select the appropriate image quality settings and try to send the fax again:
To maintain the quality of a large document, divide it into smaller batches and send them as separate faxes.
If the document contains fine text or photographs, send it directly rather than using a memory transmission.
If the document does not contain fine text or photographs, set the resolution to <200 x 100 dpi (Normal)>.
|
|
Print, send, or delete jobs stored in memory.
|
|
Set a lower image quality. Setting the resolution to <200 x 100 dpi (Normal)> will reduce the transmission time.
|
|
Make sure that the telephone line is not receiving interference from nearby devices such as a microwave oven.
|
When a fax printed out by the recipient's machine has spots:Make a copy on a blank sheet and check to see if there are any spots on the feeder's scanning area. Clean the feeder's scanning area to remove the spots if necessary. If the copy is not spotted, the problem may lie with the recipient's machine.
Make sure that the document is properly loaded.
|
When a fax printed out by the recipient's machine is smaller than its actual size:Contact the recipient and ensure that the recipient is using the proper size setting for received faxes.
|
When the contrast of the printed fax is too light or dark:Adjust the density setting.
Make sure that the feeder's scanning area is clean.
|
|
Select <Sharpness> from the Fax mode screen, and adjust to <-> level.
Select <Resolution> from the Fax mode screen, and then specify to <200 x 200 dpi (Photo)>.
|