Configuring SMB
Server Message Block (SMB) is a protocol for sharing resources, such as files and printers, with more than one device in a network and used to register the machine as a shared printer on the SMB network.
|
|
|
SMB supports only NetBIOS over TCP/IP and does not support NetBEUI. Configure the IP address before configuring the SMB settings. Setting IP Addresses
SMB is enabled only when the optional SD card is installed in the machine.
|
1
Start the Remote UI and log on in Management Mode. Starting the Remote UI
2
Click [Settings/Registration].
3
Click [Network] 
[SMB Settings].
[SMB Settings].
4
Click [Edit].
5
Select the [Use SMB Server] check box and specify the required settings.
[Use SMB Server]
If you select the check box, the computer is indicated as an SMB server on the SMB network. When not using SMB, clear the check box. You can also specify whether to use the SMB server from the operation panel (SMB).
[Server Name]
Enter up to 15 characters for the server name that is to be displayed on the SMB network. The name must be different from the names of any other computers and printers on the network.
You cannot use spaces.
A server name set in [SMB Server Name] under [WINS Configuration] is automatically used for [Server Name], if any. A change to the server name in [Server Name] is also applied to [SMB Server Name] under [WINS Configuration].
[Workgroup Name]
Enter up to 15 characters for the name of the workgroup the machine belongs to. If there is no workgroup in your network environment, create a workgroup on Windows and enter the name of the workgroup.
You cannot use spaces.
A workgroup name set in [SMB Workgroup Name] under [WINS Configuration] is automatically used for [Workgroup Name], if any. A change to the server name in [Workgroup Name] is also applied to [SMB Workgroup Name] under [WINS Configuration].
[Comments]
Enter up to 48 characters for comments on the machine as necessary.
[Use LM Announce]
Select the check box to notify the LAN Manager of existence of the machine. If you do not need to notify, clear the check box, reducing a network load.
[Use SMB Printing]
When using SMB printing with the machine, select the check box. When not using, clear the check box. You can also specify whether to use the SMB Print function from the operation panel (SMB).
[Printer Name]
Enter up to 13 characters for the name of the machine.
You cannot use spaces.
6
Click [OK].
7
Perform a hard reset.
Click [Device Control], select [Hard Reset], and then click [Execute].
 |
The settings are enabled after the hard reset is performed.
|
»
Continue to Configuring Settings on the Computer for Printing.