Installing ROM

NOTE
A Phillips screwdriver is required.
Have a screwdriver ready that matches the size of the screws for the slot cover.
1
Turn the printer OFF, and then disconnect the cables or cords from the printer.
Shut down the printer before turning it OFF.
For details on the procedure for shutting down the printer, see "Turning the Printer ON/OFF."
<How to disconnect the cable or cord>
USB cable*
(2) Turn the computer OFF.
(3) Disconnect the cable from the printer.
LAN cable*
(4) Disconnect the cable from the printer.
Power cord
(5) Disconnect the power plug from the AC power outlet.
(6) Disconnect the cord from the printer.
*
Whether the cable is connected or not varies depending on your environment.
2
Remove the slot cover.
(1)
Remove the screws marked with "  " or "  ".
(2)
Open the slot cover.
(3)
Remove the cover in the direction of the arrow.
NOTE
About the location for installing ROM
Confirm the installation location and its orientation before installing the ROM module.
3
Install ROM.
Push the ROM module into the printer firmly while aligning the module with the two connectors.
4
Attach the slot cover.
(1)
Attach the slot cover.
(2)
Close the cover.
5
Attach and fasten the screw.
Next, perform the following procedures. (If you want to install the SD card, follow the procedure from Step 2 in "Installing SD Card".)
If you install the printer and ROM at the same time
1
Connect the power cord.
2
Specifying the printer's initial settings.
Specifying a type of printer driver.
3
Load paper.
4
Connecting to a computer.
5
Install the printer driver.
6
Check the printing operation.
Check the operations by Test Page in Windows.
7
Check the ROM installation.
8
Specify the settings for the ROM module as needed.
For details on the settings for the bar code fonts, see "Bar Code Printing Guide" included in the User Manual CD-ROM.
If you installed ROM afterward (If you are using the printer already)
1
Connect the cables and cords.
Connect the removed cables and cords again.
2
Check the ROM installation.
3
Specify the settings for the ROM module as needed.
For details on the settings for the bar code fonts, see "Bar Code Printing Guide" included in the User Manual CD-ROM.
07YS-029