Setting the IPv4 Address

Before setting the IP address, see "Attention (Setting the IPv4 Address)."
By default, the IPv4 address is obtained automatically.
The procedure below describes how to manually specify this IP address.
IMPORTANT
When the setup is complete:
You must restart the machine to activate these settings.
1
Press [] (Settings/Registration).
2
Press [] or [] to highlight <System Management Settings>, and then press [OK].
If System Manager Information Settings are specified:
Use the numeric keys to enter the System Manager ID and PIN, and then press [OK].
Press  (Log In/Out).
3
Press [] or [] to highlight <Network Settings>, and then press [OK].
4
Press [] or [] to highlight <TCP/IP Settings>, and then press [OK].
5
Press [] or [] to highlight <IPv4 Settings>, and then press [OK].
6
Press [] or [] to highlight <IP Address Settings>, and then press [OK].
7
Press [] or [] to highlight the method for setting the IP address.
<Auto Acquire>
Set the IP address using any of DHCP, BOOTP, RARP or Auto IP.
<Manually Acquire>
Manually assign an IP address for the machine.
This setting can be specified only when <Select Protocol> and <Auto IP> in <Auto Acquire> are set to <Off>.
8
Change the IP address settings.
For <Auto Acquire>:
For <Manually Acquire>:
For <Auto Acquire>:
(1)
Change <Auto Acquire> settings.
<Select Protocol>
<Off>
Set the IP address settings not to obtain the IP address automatically.
<DHCP>
Obtains the IP address using DHCP. (The DHCP server needs to be running.)
<BOOTP>
Obtains the IP address using BOOTP. (The BOOTP daemon needs to be running.)
<RARP>
Obtains the IP address using RARP. (The RARP daemon needs to be running.)
<Auto IP>
<Off>
Set the IP address settings not to obtain the IP address automatically.
<On>
The machine obtains the IP address automatically.
(2)
Press [] or [] to highlight <Apply>, and then press [OK].
For <Manually Acquire>:
This setting can be specified only when <Select Protocol> and <Auto IP> in <Auto Acquire> are set to <Off>.
(1)
Enter the IP address.
After it has been entered, press [OK].
(2)
Enter the subnet mask.
After it has been entered, press [OK].
(3)
Enter the gateway address.
After it has been entered, press [OK].
9
Press [] (Settings/Registration) to close the Settings/Registration screen.
10
Restart the machine.
It is necessary to restart the machine to take effect the settings.
Turn OFF the machine and wait for at least 10 seconds before turning it back ON.
0J04-0A4