Operations from the Error Information Screen
This section describes operations that can be performed from the error information screen.
|
NOTE
|
|
When there are no errors, the error information screen is not displayed.
|
1
Press [
] (Status Monitor).
] (Status Monitor).The Status Monitor screen is displayed.
2
Press [
] or [
] to highlight <Error Information>, and then press [OK].
] or [] to highlight <Error Information>, and then press [OK].
The top page of the error list screen is displayed.
3
Check the error status.
The following errors are displayed.
[No Paper]: Load paper as necessary into the drawer or multi-purpose tray which has run out of paper.
[Size/Settings Mismatch]: This is displayed when the size of paper loaded in the drawer is different from the size set on the screens for selecting/setting the paper sources and sizes. For details, see "When <Size/Settings Mismatch> Appears."
[Front/Left Cover Open]: Follow the instructions on the screen to resolve the error. For details, see "Problem Solving."
[Drum Cartridge Not Inserted]: Follow the instructions on the screen to resolve the error. For details, see "Replacing the Drum Unit."
[Prepare Toner Cartridge]: Follow the instructions on the screen to resolve the error. For details, see "Replacing Toner Cartridges."
[Clean Original Scanning Area]: Follow the instructions on the screen to resolve the error. For details, see "Cleaning the Platen Glass."
|
NOTE
|
|
For more information on paper size settings, see "Supported Paper Types."
|
4
Press [] (Status Monitor) to close the Status Monitor screen.
] (Status Monitor) to close the Status Monitor screen.