Setting IPv4 Address

 
The machine's IPv4 address can be either assigned automatically by a dynamic IP addressing protocol, such as DHCP, or entered manually. When connecting the machine to a wired LAN, make sure that the connectors of the LAN cable are firmly inserted into the ports (Connecting to a Wired LAN).

Setting IPv4 Address

1
Press  ().
2
Use / to select <Network>, and press .
When a message appears, press .
3
Select <TCP/IP Settings>  <IPv4 Settings>  <IP Mode>.
4
Configure IP address settings.
 <Auto>
Select to automatically assign an IP address via a protocol such as DHCP.
 <Manual>
Select to configure the IP address settings by manually entering an IP address.
Automatically assigning an IP address
1
Select <Auto>, and press .
2
Select <Protocol>, and press .
3
Select <Use DHCP>, <Use BOOTP>, or <Use RARP>, and press .
You can use only one of the protocols DHCP, BOOTP, and RARP. If the selected protocol is set to <On>, the other two protocols are automatically set to <Off>.
4
Select <On>, and press .
5
Press .
6
Select <Auto IP>, and press .
7
Select <On>, and press .
When using DHCP
If you turn OFF the power and ON again, an IP address differing from the current one will be assigned. This may disable printing. To use DHCP, specify one of the following settings after consulting the network administrator.
Configuring the DNS Dynamic Update Function Configuring DNS
Specifying Settings for the DHCP Server to Constantly Assign the Same IP Address
If you do not want to use DHCP/BOOTP/RARP to assign an IP address
Set all the protocols to <Off>. If you set <Use DHCP>, <Use BOOTP>, or <Use RARP> to <On> when the DHCP/BOOTP/RARP servers are unavailable, the machine will waste time and communication resources in searching the network for available services.
IP addresses that are given precedence
IP addresses assigned via DHCP/BOOTP/RARP override the address obtained via Auto IP.
Manually entering an IP address
1
Select <Manual>, and press .
2
Select <IP Address Settings>, and press .
3
Specify the IP address, subnet mask, and gateway address (or default gateway).
Select the item to set, press , enter an address, and press .
How to enter addresses
Use / to move to the target field (a period-delimited input area), and use the numeric keys to increase/decrease the value.
When you are unsure of the IP address to input
The IP address can be determined from the router settings of the network. Determining the IP Address to Assign to the Machine
5
Perform a hard reset. Performing a Hard Reset
The settings are enabled after the hard reset is performed.
Checking whether the settings are correct
Make sure that the Remote UI screen can be displayed with your computer. Starting Remote UI
If you have changed the IP address after installing the printer driver
By following the procedure for changing the standard TCP/IP port described in the "Printer Driver Installation Guide", specify the port to use again.

Determining the IP Address to Assign to the Machine

When you want to use a fixed IP address for the machine, you can determine the IP address as shown below.
0X7U-031