Interface

All the settings about interfaces for communications with a computer and USB are listed with short descriptions. Default settings are marked with a dagger ().
Asterisks (*)
Settings marked with an asterisk (*) are not displayed depending on other settings.

Interface Selection

Select the interface used for the machine.
USB
Enable or disable the USB port. Restricting the USB Connection with a Computer
Off
On
Network
Enable or disable the LAN port. Disabling the LAN Port
Off
On
USB Adv. Functions
Specify settings for selecting a function to use a USB device or selecting a device driver to use.
Adv. Func. Settings
Select which of MEAP applications and USB over NW to be given priority when a USB device is connected to the machine.
Meap Priority
USB Over NW Priority
USB Storage Device
Specify settings for the device driver for using a USB memory device.
MEAP Driver
Enable or disable the MEAP specific device driver when a USB memory device is attached to the machine. When you want to perform the direct print function (USB Direct Print) from a USB memory device without using a computer, select <Off>.
Off
On

Timeout

Specify how the machine should behave if receiving print data is interrupted.
Timeout
Select whether to cancel printing if print data receiving is interrupted for a specified period of time.
Off
On
Timeout Time *
Set the time period until a timeout error occurs.
5 to 15 to 300 (seconds)

Connection Recog.

A problem such as improper overlay printing or garbled characters may occur during printing via wired LAN connection. In this case, set <Connection Recog.> to <Off>.
Off
On

Extended RX Buffer

Select whether to increase the space of the memory built in the machine for receiving print data from a computer. If you select <On>, the time until the computer will be freed from print data processing or transmission can be reduced when the computer sends a large volume of data or complicatedly structured data.
Off
On
0YS1-05K